Pump Service Across Kent, Surrey, Sussex, Essex & London
Servicing, cleaning and emergency repair of sewage and surface water pump stations across domestic, commercial and industrial sites in Kent, Surrey, Sussex, Essex & London.
Get a Free Quote
We'll get back to you fast — usually within the hour.
"*" indicates required fields
What we offer
A failed pump stops the whole building from working
For properties below the level of the main sewer - basement flats, commercial sites below ground floor, riverside developments - the pump station is the piece of infrastructure that keeps the whole building working. When it fails, every toilet, sink and waste outlet stops moving within minutes. Planned maintenance is dramatically cheaper than the emergency replacement that follows neglect.
Call2Drain services pump stations on annual, bi-annual or quarterly schedules depending on the duty cycle. Each service covers the wet well (silt and grease removal), the pumps (impeller, seal and bearing inspection), the float switches or level sensors, and the control panel (sequencing, alarm function, insulation testing).
For emergency call-outs we carry replacement pumps for most common domestic and light commercial systems on the van. Where we cannot fix on the day, a hire pump can be put in place to keep the building working until a permanent replacement is installed.
Service contracts
Keep it running
A failed pump stops the whole building within minutes
For any property below the level of the main sewer — basement flats, riverside developments, commercial units below ground floor — the pump station keeps every toilet, sink and waste outlet moving. When it fails, the building stops; planned maintenance is dramatically cheaper than the emergency replacement that follows neglect.
We service sewage and surface-water pump stations across Kent, Surrey, Sussex, Essex & London on annual, bi-annual or quarterly schedules, covering the wet well, the pumps, the float switches and the control panel. For emergencies we carry replacement pumps for most common systems, with hire pumps available to keep the building running.
- Wet-well silt and grease removal
- Pump lift-out, impeller, seal and bearing inspection
- Float switch, panel and alarm testing under load
- Replacement and hire pumps for emergencies
How it works
How a pump station service works
Empty and inspect
Vacuum the wet well, lift each pump, inspect impeller, seals and bearings.
Test and reset
Float switches, control panel, duty/standby sequencing and alarm function all checked under load.
Report
Written service report with photos, condition, and any recommended replacement parts.
FAQs
Common questions
How often should a pump station be serviced?
Domestic packaged stations: annual. Light commercial: bi-annual. Heavy-duty (restaurants, hotels): quarterly.
What if the alarm has triggered now?
Limit water use across the building immediately and call 01892 571 555 for a same-day emergency call-out. We carry replacement pumps for most common systems.
How long do pumps last?
Submersible motors typically last 8 to 15 years depending on duty cycle and maintenance. Regular service materially extends the life.
Coverage
Pump Service across Kent, Surrey, Sussex, Essex & London
Ready to book?
Set up a pump station service contract
Call 01892 571 555 for a tailored service schedule. Annual, bi-annual or quarterly visits with written condition reports.
Get a fixed-price quote
"*" indicates required fields